Gateways

[Andrew Hodgson]

Hi all,

I decided to update my fb to the latest firmware and reinit it to
factory settings to see if I could do it without the wizard. It seems
to be working fine, but with the gateway settings, I have set my WAN
subnet with a gateway, but only seem to be able to get it working if I
specify in setup that the default route should go through my specific
WAN subnet, and not any WAN subnet. I wanted to put in the "any"
option, so that I am not tied down to a particular subnet - I don't
have to change things in two places.

Any suggestions?

Thanks.
Andrew.

[Rev Adrian Kennard]

Post by Andrew Hodgson
Hi all,
I decided to update my fb to the latest firmware and reinit it to
factory settings to see if I could do it without the wizard. It seems
to be working fine, but with the gateway settings, I have set my WAN
subnet with a gateway, but only seem to be able to get it working if I
specify in setup that the default route should go through my specific
WAN subnet, and not any WAN subnet. I wanted to put in the "any"
option, so that I am not tied down to a particular subnet - I don't
have to change things in two places.
Any suggestions?

You should be able to put WAN(Any) and specify a gateway address in the
setup->gateway settings. If not setting a gateway address, then you
would need WAN(something) so it can look it up.

- --
_ Rev. Adrian Kennard, Andrews & Arnold Ltd / AAISP
(_) _| _ . _ _ Broadband, fixed IPs, no min term http://adsl.ms/
( )(_|( |(_|| ) Asterisk VoIP based PABXs, SNOM190 http://aa.gg/
~~~~~~~~~~~~~~~~ Bond two ADSL lines? http://www.FireBrick.info/